The C SUB family of subwoofers are extremely high-powered, offering high efficiency and impressive low bass performance. They are optimised for use with the CONTOUR X point sound sources and the COSMO line arrays, with components and workmanship that meet the same high standards.

Flexibility

The C SUB subwoofers offer a total of four Speakon NL4 connectors (two at the rear and two at the front for easy cabling, for example in Cardioid or Endfire setups). The desired signal from a four-wire cable can be assigned to a C SUB using the pin assignment switch.

Both the CS 118 and the CS 218 are perfectly matched in their frequency and phase response, as well as in their cabinet dimensions. This makes it possible to effortlessly combine them to form perfectly tuned clusters.

Mechanics

The birch multiplex cabinets are PU-coated, while the solid steel front grilles are treated with an anti-corrosive finish. The Speakon connection sockets are protected against the ingress of dirt and moisture by sealing caps. All in all, the C SUBs offer all the prerequisites for high value retention and long, uninterrupted operation in the rough everyday conditions of professional users.

Efficiency

We recommend the high-performance Lab.Gruppen PLM+ or Powersoft X series power amps for use with these high-power subwoofers. Optimised filter settings are also available for these controller amps for creating Cardioid or Endfire arrangements.

CS 118

The C SUB CS 118 is a compact, direct radiating 1 x 18″ subwoofer, the ideal low-end addition to the COSMO line array and the CONTOUR X point sound sources. The high efficiency and extremely high power handling capacity provide an extraordinarily large dynamic headroom down to the lowest frequencies. The total of four Speakon NL4 connectors are fully through-connected, and the pin assignment switch can be used to assign the CS 118 to one of the two speaker paths. There are two Speakon NL4 connectors at the back and two at the front, making the cabling of cardioid setups quicker and easier to implement.

The powerful Lab.Gruppen PLM+ or Powersoft X Series power amplifiers are recommended for use with the CS 118. Optimised filter settings are also available for these controller amps for creating Cardioid or Endfire arrangements. The birch multiplex cabinets are PU-coated, while the solid steel front grille features an anti-corrosive, powder-coated finish. The Speakon input sockets are protected against the ingress of dirt and moisture by sealing caps. All in all, the C SUB CS 118 has all the prerequisites for long and uninterrupted operation in the rough everyday rental business.

CS 218

The C SUB CS 218 is a compact, direct radiating 2 x 18″ subwoofer, the ideal low-end addition to the COSMO line array and the CONTOUR X point sound sources. The CS 218 and CS 118 subwoofers are the perfect match acoustically, in their phase and in their cabinet dimensions and can thus be easily combined to form perfectly tuned sub-clusters. As with the smaller CS 118, the dimensions are based on the standardised pallet or truck dimensions.

The high efficiency and extremely high power handling capacity provide an extraordinarily large dynamic headroom down to the lowest frequencies. The total of four Speakon NL4 connectors are fully through-connected, and the pin assignment switch can be used to assign the CS 218 to one of the two speaker paths. There are two Speakon NL4 connectors at the back and two at the front, making the cabling of cardioid setups quicker and easier to implement.

The powerful Lab.Gruppen PLM+ or Powersoft X Series power amplifiers are recommended for use with the CS 218. Optimised filter settings are also available for these controller amps for creating Cardioid or Endfire arrangements. The birch multiplex cabinets are PU-coated, while the solid steel front grille features an anti-corrosive, powder-coated finish. The Speakon input sockets are protected against the ingress of dirt and moisture by sealing caps. All in all, the C SUB CS 218 has all the prerequisites for long and uninterrupted operation in the rough everyday rental business.

CF 118

The compact, direct-radiating, high-performance 1×18″ subwoofer with COSMO’s modular dimensions of 60 cm is the flyable version of the CS 118 subwoofer. Its high efficiency and extremely high power handling capacity provide an extraordinarily large dynamic headroom down to the lowest frequencies. It is ideal for all applications where there is no room for placing bass enclosures and is also suitable for ground-stack setups with COSMO or CONTOUR X components.

Compared to other subwoofers in its power range, there are considerably fewer components covering the full spectrum of what users need and expect from an FoH system. This extends the operating periods of each component compared to other system families. For the CF 118 we provide ready-to-use filter sets for Lab.Gruppen PLM+ or Powersoft X power amplifiers. Optimised filter settings make it possible to quickly set up Cardioid or Endfire arrangements, among others.

The uniform dimensions of the COSMO family simplify both storage and disposition, which has a positive impact on the warehousing in total. The simple handling results in enormous time savings, as well as reduced training requirements. An existing system can be expanded precisely as needed, all of which means an even more effective investment protection than usual is ensured. The expansion in small steps creates a much lower investment requirement.

Accessories

CF-DO

The multifunctional CF-DO Transport Dolly is used to safely transport the COSMO C 6, C 8 and C 10 mid/high units or the CF 118 subwoofer. If it is only being used to transport mid/high units, the flying frame can also be attached at the rear. The CF-DO can be used for ground-stack applications by using the optionally available CF-DO Extension.

CF-DO Extension

The CF-DO Extension is an extension for the COSMO CF-DO Transport Dolly. The CF-DO Extension allows for quick and straightforward ground-stack applications with the flyable CF 118 subwoofer together with the C 6, C 8 or C 10 mid/high units of the COSMO Line Array series. The package contains the CF-DO Extension and an installation manual. The CF-DO Extension requires a CF-DO from the COSMO series.

CS-WB 1

The CS-WB 1 is the ideal addition for transporting the subwoofers of the C SUB series. It has space for up to two CS 118 subwoofers. A matching protective cover is optionally available to protect the subwoofers during transport. The CS-WB 1 also comes with a lashing strap for securely attaching the C SUB subwoofers to the wheelboard.

CS-WB 1 Cover

The CS-WB 1 Cover is a clever transport protection cover for use with the subwoofers of the C SUB series. It offers coverable access to the connections, the speaker flange and the transport handles.

CS-WB 2 – Wheelboard

The CS-WB 2 is the ideal addition for transporting the subwoofers of the C SUB series. It has space for up to two CS 218 subwoofers or four CS 118 subwoofers. A matching protective cover is optionally available to protect the subwoofers during transport. The CS-WB 2 also comes with a lashing strap for securely attaching the C SUB subwoofers to the wheelboard.

CS-WB 2 – Wheelboard Cover

The CS-WB 2 Cover is a clever transport protection cover for use with the subwoofers of the C SUB series. It offers coverable access to the connections, the speaker flange and the transport handles.

CRF-60

The CRF-60 COSMO series flying frame can be used in flying applications for smaller line arrays containing the C 6, C 8 and C 10. With the C-M20 adapter, the frame serves as a connection between C SUB and the COSMO m/h units in ground-stack operation. The comprehensive package includes everything required for installation and use. And of course, the CRF-60 supports the COSMO family’s transport and logistics concept, thus simplifying not only transport but also disposition.

CRF-80

The CRF-80 COSMO series flying frame can be used in flying applications with larger C 6, C 8 and C 10 setups and with the CF 118 as well as for creating ground-stack setups. With the C-M20 adapter, the frame serves as a connection between C SUB and COSMO m/h units in ground-stack operation. The comprehensive package includes everything required for installation and use. And of course, the CRF-80 supports the COSMO family’s transport and logistics concept, thus simplifying not only transport but also disposition.

CRF-PB

The COSMO CRF-PB Pull-Back Frame is used for Compressed Mode by means of a lashing strap for a COSMO line array setup. It is also ideal for mounting COSMO mid/high units on tripods using flange adapters and for implementing smaller ground-stack setups.

Downloads

Select category or search...

Product management

Music & Sales Professional Equipment GmbH
Wendelinuspark
Tritschlerstraße 3
66606 St. Wendel
Germany

Email: lreime@musicandsales.com
Tel: +49 6851 905 279

Service

Music & Sales Professional Equipment GmbH
Wendelinuspark
Tritschlerstraße 3
66606 St. Wendel
Germany

Email: service@musicandsales.com

Are you interested in an HK Audio product?

Use our dealer search to find a distributor and dealer near you.